Add : 3-7, 1 Floor, Block C, No.23 Panlong Industrial Zone, Longxi Road, Guangzhou, China
Products
- China
- ZLT-DTC
- Guangzhou
- 1
- In 25 Working Days
- T/T, D/P
Lampholder Contacts Security Test Device
Product details: Model ZLT-DTC.
To check the security of lampholder contacts, and conform to the IEC60598-2-20 Fig 2 and clause 20.11.3.
The incandescent lamp is removed and a force of 15 N is applied for 1 min to each of the conductors connected. Following this, a force of 30 N is applied for 1 min to the two conductors together. The forces are applied at a distance of 3 ± 0.8 mm from the insertion points in the lampholder so as to try to move the contacts from the lampholders. During the test the contacts shall not move more than 0.8 mm.
Previous: Toaster Switch Endurance Test Machine
Next: Flexible Pipe Winding Test Device
Related Products-
ZLT-GC1, to determine the adherence and the durabi...
-
ZLT-IF1. To determine the mechanical strength of e...
-
ZLT-VL120. This Test Vessel confirms to the IEC 60...
-
ZLT-WD1. Table Diameter :600mm ,to determine the s...
-
Flexible Pipe Winding Test Device
ZLT-SDW1. To determine the mechanical strength of ... -
Toaster Switch Endurance Test Machine
ZLT-DSK. To determine on off life of switch of the... -
Cordless Kettle Insert Pull Tester
ZLT-SW1. To use for the insert-pull test of cordle... -
ZLT-LWM1. To determine the torque strength of the ...
-
Automatic Cord Reels Endurance Tester
ZLT-JX1. To determine endurance of automatic cord ... -
Microwave Oven Door Endurance Tester
ZLT-WM1T. To determine the endurance of the door s... -
Load for Testing Rotating Spits
ZLT-LR. This load confirms to the IEC60335-2... -
ZLT-BDK. To measure the temperatures, accordi...