Add : 3-7, 1 Floor, Block C, No.23 Panlong Industrial Zone, Longxi Road, Guangzhou, China
Products
- China
- ZLT-GT2
- Guangzhou
- 1
- In 25 Working Days
- T/T , D/P
Tumbling Barrel Lab Test Apparatus
Product details: ZLT-GT2
The ZLT Tumbling Barrel Tester simulates repeated falls which may occur to such devices as connectors or small remote control units which are normally attached to cables during use.
②Model:ZLT-GT2, is to determine the mechanical strength of electrical appliances or electrical components in accordance with IEC60068-2-32 Amendment 2,employs a large clear acrylic access door for easy viewing and access to the chamber.
Inner height: 675mm or 1175mm(for 1m fall height)
Fall height: 500mm or 1000mm.
Chute length: 275mm.
Bottom Impact Surface: 3mm steel backed with 19mm hardwood.
①Model:ZLT GT1, is to determine the mechanical strength of lamp or electrical appliances or electrical components in accordance with IEC60598 figure 25 and VDE0620 Bild 27.
Power Supply: A.C.220V 50Hz, other voltages and frequencies on request.Rate of falls: 10 times/min.
Speed of rotation: 5 r/min.
Inner height: 650mm.
Fall height: 500mm.
Chute Length: 275mm.
Bottom Impact Surface: 3mm steel.
③Model:ZLT-GT3, similar to ZLT-GT2, but according to BS1363 figure 20.
Inner height: 650mm.Fall height: 500mm.
Bottom Impact Surface: 19mm nominal thick blockboard or suitable alternative.
④Model:ZLT-GT4, similar to ZLT-GT2, but of larger dimensions for testing of accessories for vacuum cleaners, according to IEC60312 figure 16.
Inner height: 1070mm.
Fall height: 800mm.
Chute length: 400mm.
Bottom Impact Surface: 5mm steel and hard wooden plate.
Previous: Tumbling Barrel Testing Machine
Next: Drop And Fall Tester
Related Products-
Plug and Socket Endurance Testing Machin...
ZLT-CS1, to test plugs and socket-outlets, cable c... -
ZLT-LJ2, for measuring and testing the torque stra... -
ZLT-DW2, for continuous bending tests by swivellin... -
Equipment to Load the Samples with Curre...
ZLT-HZ1, installed into the test machine ZLT-DW2, ... -
Cord Anchorage Torque Test Device
ZLT-LJ3, this device is for testing the resistance... -
ZLT-QY1, to determine the dimensional stability of... -
ZLT-GT1, is to determine the mechanical strength o... -
Cord Anchorage Testing Machine
ZLT-DY1, for testing cable connections with interm... -
Heat Compression Test Apparatus
ZLT-RS1, to determine the verification of resistan... -
Verify the Fixation of Pins in the Body ...
ZLT-CX1, to determine the fixation of pins in the ... -
Socket Plug Strength Test Device
ZLT-CB1, for verification of the maximum and minim... -
ZLT-HP1, for pressure tests on plug pin insulating...
