Add : 3-7, 1 Floor, Block C, No.23 Panlong Industrial Zone, Longxi Road, Guangzhou, China
News&Successful Cases
2015-12-08
Needle flame test for hand held motor operated electric tools
Based on IEC 60745 Annex F, the needle flame burner test is made in accordence with IEC 60695-11-5.
In case where burning or glowing particles might fall form the specimen onto an external surface underneath the tool, the test is made with a pieces of white pine-wood board, approximately 10mm thick, and covered with a single layer of tissue paper, positioned at a distance of 200 mm ±5mm below the place where the test flame is applied to the specimen, If the tool as a whole is tested, it is placed in its normal position of use above the pine-wood board, which is covered with a single layer of tissue paper.
When a layer of tissue paper is used, there shall be no ignition of the tissue paper, or scorching of white pine-wood board; a slight discoloration of the white pine-wood board being neglected
Previous : The glow wire test for Self-ballasted lamps for general lighting services
Next : Glow wire test for hand held motor operated electric tools