Add : 3-7, 1 Floor, Block C, No.23 Panlong Industrial Zone, Longxi Road, Guangzhou, China
Products
Tumbling Barrel Testing Machine
Product details: ZLT-GT3A
The ZLT Tumbling Barrel Tester simulates repeated falls which may occur to such devices as connectors or small remote control units which are normally attached to cables during use.
Model:ZLT-GT3A, similar to ZLT-GT2, but according to IEC60730 figure 5.
Inner height: 650mm.
Fall height: 500mm.
Bottom Impact Surface: 19mm nominal thick blockboard or suitable alternative,impact base 3 mm thick steel plate.
Previous: Cord Anchorage Torque Test Apparatus
Next: Tumbling Barrel Lab Test Apparatus
Related Products-
Plug and Socket Endurance Testing Machin...
ZLT-CS1, to test plugs and socket-outlets, cable c... -
ZLT-LJ2, for measuring and testing the torque stra...
-
ZLT-DW2, for continuous bending tests by swivellin...
-
Equipment to Load the Samples with Curre...
ZLT-HZ1, installed into the test machine ZLT-DW2, ... -
Cord Anchorage Torque Test Device
ZLT-LJ3, this device is for testing the resistance... -
ZLT-QY1, to determine the dimensional stability of...
-
ZLT-GT1, is to determine the mechanical strength o...
-
Cord Anchorage Testing Machine
ZLT-DY1, for testing cable connections with interm... -
Heat Compression Test Apparatus
ZLT-RS1, to determine the verification of resistan... -
Verify the Fixation of Pins in the Body ...
ZLT-CX1, to determine the fixation of pins in the ... -
Socket Plug Strength Test Device
ZLT-CB1, for verification of the maximum and minim... -
ZLT-HP1, for pressure tests on plug pin insulating...