Add : 3-7, 1 Floor, Block C, No.23 Panlong Industrial Zone, Longxi Road, Guangzhou, China
Products
Power Cord Flexibility Tester
Product details: Model ZLT-JDW1R.
The part of the appliance that includes the inlet opening is fixed to the oscillating member so that, when the supply cord is at the middle of its travel, the axis of the cord where it enters the cord guard or inlet is vertical and passes through the axis of oscillation. The major axis of the section of flat cords shall be parallel to the axis of oscillation.
The cord is loaded so that the force applied is
– 10 N, for cords having a nominal cross-sectional area exceeding 0,75 mm2;
– 5 N, for other cords.
The distance X, as shown in IEC60335 figure 8, between the axis of oscillation and the point where the cord or cord guard enters the appliance, is adjusted so that when the oscillating member moves over its full range, the cord and load make the minimum lateral movement.
The oscillating member is moved through an angle of 90° (45° on either side of the vertical), the number of flexing for type Z attachments being 20 000 and for other attachments 10 000. The rate of flexing is 60 per minute.
Standard Outfit:
1 electric drive motor with reduction and swiveling gear,
1 output shaft, swiveling angle 45°,60°or 90°on either side of the vertical,
1 sets of weights, 5N-10N,
1 speed adjustment, for swiveling frequency 10~60 rpm,
1 control unit with 6 digit predetermining counter to switch off the drive, and records the number of swiveling when the sample open circuit,
1 control circuit of 3 KVA power output, power supply to specimen,
Power Supply: A.C.220V 50Hz, other voltages and frequencies on request.
Previous: Cold Bend Test Apparatus
Next: Power Cord Strain and Twist Tester
Related Products-
Internal Wire Flexibility Tester
ZLT-WM1A, in accordance with IEC60335-1 clause 23.... -
Flexible Cables Flexing Tester ZLT-QL1
ZLT-QL1. This Tester is checking mechanical streng... -
ZLT-JDW1. For continuous bending tests by swivelin...
-
Abrasion Resistance Testing Machine
ZLT-DYJ2. To determine the durability of cable cov... -
ZLT-JDW3R. For continuous bending tests by swiveli...
-
Tinsel Cord Bending Test Apparatus
ZLT-JDW2R. To determine the bendability of the tin... -
Power Cord Strain and Twist Tester
ZLT-LN1. To determine the strain and twisting of t... -
ZLT-SDJ1. To determine the bending stability at lo...
-
Thermal Deformation Test Device
ZLT-JR1. To determine the deformation which wire i... -
Tinsel Cord Snatch Test Device
ZLT-ST2, to determine the impactive effect of... -
Three Pulley And Two Pulley Cable Flexin...
ZLT-QL1A. adding three pulley flexing t... -
Flexible Cord Abrupt Pull Test Apparatus
Conform to UL 817 clause 99 and figure 99.1 -99.2,...